BPC PowerMaster Manuel du propriétaire télécharger pdf (Page 8)

Supplying power to your LEGACY PowerMaster

he LEGACY PowerMaster receives its power from an external power supply. It has

been designed to operate with the Lionel 135W PowerHouse (6-12866) and the 180W

PowerHouse (6-22983). It may also be used with any traditional transformer producng up

to 20 VAC with a current rating of 7-10 amps. Use only traditional transformers that have a

pure sine wave output such as the Lionel Postwar ZW, Lionel KW, MTH Z-4000, and similar

transformers. Operation with transformers that have a chopped sine wave output such as the

MTH Z-750, MTH Z-1000, MRC DualPower 027, Lionel CW-80 or similar transformers will

result in unpredicable operation. To make the proper connections to a traditional transformer,

you need a Power Adapter Cable (available separately, 6-12893).

Connecting your PowerMaster to a PowerHouse power supply

1. Insert the Power House Power Supply’s connector plug into the PowerMaster’s connector

jack. Refer to Figure 5 below.

2. On the PowerMaster, set the power selection switch to 135 or 180 watts, depending on the

type of PowerHouse Power Supply you are using.

3. Plug the PowerHouse Power Supply into a wall outlet (120 volts, 60 Hertz).

Always switch off the PowerHouse Power Supply when you are not operating your

railroad.

PROG/RUN

CMD/CONV

180

135

Power selection switch

PowerHouse Power

Supply plug

Figure 5. PowerMaster Installation

Note!

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

BPC PowerMaster Manuel du propriétaire Page 8