BPC PowerMaster Manuel du propriétaire télécharger pdf (Page 12)

efore you operate the LEGACY PowerMaster with the TrainMaster Command Control System, you

will need to assign a unique ID# to the PowerMaster.

The LEGACY PowerMaster receives signals from the LEGACY 455 MHz track signal.

1. Connect the “U” terminal of a TrainMaster Command Control Base (6-12911) to the “U”

terminal of the PowerMaster or to the outside rail of the track.

2. Plug in the TrainMaster Command Base and turn on the power to the PowerMaster.

3. Set the PROG/RUN switch on the PowerMaster to the PROG position.

4. Press ENG or TR on the CAB-1 or CAB-IL.

5. Enter the unique ID#. You may select any ENG ID# from 1 to 98 or any TR ID# from 1 to 9.

6. Press SET. The red light on the top of the PowerMaster will flash to indicate that the ID#

has been set.

7. Slide the PROG/RUN switch back to the RUN position.

The PowerMaster has now been assigned the ID# you selected.

TrainMaster Command Control operations

Note!

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

BPC PowerMaster Manuel du propriétaire Page 12