78-1325-250 5/14LCS PDI CABLESuse either connectorWiFi6-81325LionelWiFi Owner's Manual
10Installing a new LCS system with NO Command BaseThe Layout Control System can be used without a Lionel Command base. This would be appropriate for a
11Installing additional LCS devicesThis section describes adding a new device to an existing Layout Control System installation. If you are installing
12Configuring your LCS DeviceThe illustration below shows the name and location of each switch, connector and indicator light on your LCS WiFi module.
13Access Point ModeAccess Point mode creates an entirely new network, with an SSID of “Lionel LCS – NNNN”. The “NNNN” will represent a unique identif
14BASE / NO BASEWhen operating with a Legacy Base or Base1L the switch should be set to “BASE.” When not connected to a Lionel base the switch must be
15Specifications of the LCS WiFi Mechanical• Size: 3.7” x 2.7” x 1.2”• Mounting: Two #4 pan head sheet metal screws LCS PDI Power Draw• Idle power co
©2014 LIONEL L.L.C., CONCORD, NC 28027UNITED STATES OF AMERICAPRINTED IN CHINALionel Limited Warranty Policy & ServiceThis Lionel product, includi
2Congratulations!Your layout has always been more than the sum of its parts. But until now, combining those parts into a complete system could be a ch
3What is Lionel’s Layout Control System?LCS doesn’t replace your existing Lionel Legacy Control system. It adds to it! You can control your layout fro
4LCS WiFi ModuleThe LCS WiFi allows your smart devices to control your layout accessories and, in conjunction with a Lionel command base, your locomot
5Installing Your First LCS DeviceInstalling Your First LCS DeviceThe following section describes installation of a new LCS system. If you already have
6Installing a new LCS system with a Legacy BaseTo install a new LCS system on a layout with a Legacy Command Base:1. Turn off power to your layout an
7Installing a new LCS system with a Base-1LTo install a new LCS system on a layout with a Base-1L Command Base:1. Turn off power to your layout and B
8Installing LCS with Legacy AND TrainMaster Command BasesThe following instructions apply ONLY if you are using one or more original CAB-1 remotes wit
9Installing LCS with Legacy AND TrainMaster Command Bases (continued)Your system should resemble the figure below. Once connected and powered-up, the
Commentaires sur ces manuels